mario
Gimbal Cleaner
Posts: 2
|
Post by mario on Jul 19, 2013 9:48:17 GMT
Upgraded one Radian to a G-Lock with the CARVEC bootloader without any problem.
But when trying to connect to the G-Lock software I get a Timed out massage, connecting to the Freefly software works without any problem so the COM port is ok.
|
|
|
Post by Admin on Jul 19, 2013 11:08:42 GMT
The G-Lock software has a different protocol from the Radian system - so if the Freefly software will connect, the module is still running Radian firmware.
The solution is to program the module with the G-Lock firmware, use the PC app to load the default config to initialise everything properly then start on your personal settings.
|
|
|
Post by E-Copter on Aug 5, 2013 15:38:26 GMT
Upgraded one Radian to a G-Lock with the CARVEC bootloader without any problem. But when trying to connect to the G-Lock software I get a Timed out massage, connecting to the Freefly software works without any problem so the COM port is ok. Hi, if you quickly disconnect / reconnect the USB dongle from the USB port, it will refresh the COM port and should connect. YOu might also need to check the advanced configuration of the COM port ( please refer to the G-Lock manual) , but most of times disconnect / reconnect works fine, it's mroe a " windows" thing than anything else BEst regards Mario, Fabien
|
|