Post by E-Copter on Jul 17, 2013 22:06:21 GMT
When upgrading for the first time the firmware, and launching the G-Lock software, you will be warned that the datas ned to be reset, and this, on each axis.
It is necessary to acknowledge for resetting the values, and if you get a warning message because you did read the datas without writing them, just ignore it and approve to move further. Once the base values are injected, then, write to the module and do this for each step. This is normal as the firmware has changed and the values / variables that are stored need to be fully reset to match the new functions.
There is also a settings file that you cna use provided by John ( see attachment)
BEst regards,
Fabien
It is necessary to acknowledge for resetting the values, and if you get a warning message because you did read the datas without writing them, just ignore it and approve to move further. Once the base values are injected, then, write to the module and do this for each step. This is normal as the firmware has changed and the values / variables that are stored need to be fully reset to match the new functions.
There is also a settings file that you cna use provided by John ( see attachment)
BEst regards,
Fabien
